Page 1 of 1

(H4N Pro) No stereo when effect enabled in MTR

Posted: Wed Apr 03, 2019 1:10 pm
by Quambo
I am trying to add some EQ to input 1 and 2 in a stereo configuration in MTR mode. I can hear it in stereo when monitoring, with no effect on. I have fully panned each channel. If I link them, I still hear them I stereo. But when I enable the effect, the sound turns to mono. Same thing happens if I leave the channels unlinked and enable the effect.

I set the effect to be "flat mic" preamp, everything turned off, except for boosting the treble. I believe I also tried with preamp set of "off."

Is it supposed to allow me to do an EQ to both channels and keep stereo?

Not too hopeful, but is there a way to alter the EQ in Stereo or 4CH mode?

Thanks

Re: (H4N Pro) No stereo when effect enabled in MTR

Posted: Wed Apr 03, 2019 10:30 pm
by Wulfraed
Based upon the manual (page 82)...

When using two inputs with any effect, the two inputs are blended before going to the effect. The effect output may be stereo (I suspect for chorus, ensemble and environment reverb effects -- those often send different variations to left/right channels)

Re: (H4N Pro) No stereo when effect enabled in MTR

Posted: Thu Apr 04, 2019 11:43 am
by Quambo
Well thanks. I'll have to do EQ on my PC separately then.

PS. I did look through the manual several times and never saw that part.